Transducer Size (Millimeters)133.35
DC Resistance5.9
Resonant Frequency61.6
Half Space Sensitivity87.5
Rated Noise Power50
Test Spectrum Bandwidth60Hz - 5kHz

Transducer Size (Millimeters)133.35
DC Resistance5.9 Ω±5.0%
Resonant Frequency61.6 Hz15%
Half Space Sensitivity @ 2.83V87.5 dB±1.01
Sensitivity @ 1W/1m86.5 dB±1.01
Rated Noise Power (IEC 268-5 18.1)50 W
Test Spectrum Bandwidth60Hz - 5kHz 12 dB/Oc
Effective Piston Area89.9 cm2
Moving Mass9 g
Motor Force Factor5.9 T•m
Voice Coil Inner Diameter25.73 mm
Gap Height6 mm
Maximum Linear Excursion3.5 mm
Ferrofluid Type
Minimum Impedance6.35 Ω±7.5%
Voice Coil Inductance0.27 mH
Mechanical Q Factor2.21
Electrical Q Factor0.59
Total Q Factor0.47
Ratio131.9 fs/Qts
Energy Bandwidth Product ((1/Qes)•fs)
Suspension Compliance740.5 μm/N
Effective Cone Diameter10.7 cm
Motor Efficiency Factor5.9 (T•m2)/Ω
Voice Coil Former MaterialASV
Transducer Mass1.06 Kg
Equivalent Volume8.41 L

This 5.25 inch 8 ohm driver is a member of the high performance HDS family. A powerful ferrite magnet system is coupled to a finite element analysis designed suspension system, containing both a linear spider design and a rubber surround. The motor contains an aluminium shorting ring, which reduces coil inductance, thus providing both extended frequency response performance and reduced distortion. The long-throw voice coil ensures linear high excursion performance, needed for signal clarity. The cone necks are vented so as to reduce air compression effects under high excursion conditions. The cast aluminium basket offers structural rigidity, heat sinking capacity for the motor, and additional air venting under the spider so as to again reduce air compression effects. The cone in this model is damped black polypropylene, offering a unique visual and acoustic experience.